<VV> 5 lug conversion - needs five new holes

[Charles Cromwell]

+Larry is correct.I have converted a few early axels
to 5 lugs.
Front is easy. Just use a late spindle
Chuck
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>





--- larry@forman.net wrote:
> On Thu, 08 Jul 2004 16:51:07 -0700, Tony Underwood
> wrote:
> 
> > 
> > At 12:13 hours 07/08/2004 -0700, Lecktrix
> Electrical wrote:
> > >Can I convert my 63 to 5 lug without machining
> axles/rotors?? 
> > 
> > Yes and no...  You only actually have to drill
> > 4 extra holes, leave one stud in the axle.    
> 
> CLOSE, but not quite.  The bolt diameter is 4-1/2
> for Earlies and 4-3/4 for Lates, so you need five
> new holes for the studs.  I think one
> hole might need to be welded up to make everything
> fit, but not sure.
> 
> -- Larry
> 
> Larry Forman
> _______________________________________________
> This message was sent by the VirtualVairs mailing
> list, all copyrights are the property
> of the writer, please attribute properly. For help,
> mailto:vv-help@corvair.org
> This list sponsored by the Corvair Society of
> America, http://www.corvair.org/
> Post messages to: VirtualVairs@corvair.org
> List info:
>
http://www.vv.corvair.org/mailman/listinfo/virtualvairs
> _______________________________________________
> 



	
		
__________________________________
Do you Yahoo!?
New and Improved Yahoo! Mail - 100MB free storage!
http://promotions.yahoo.com/new_mail