<VV> Good Day for Corvair Work

UltraMonzaWest@aol.com UltraMonzaWest@aol.com
Sun, 21 Mar 2004 10:24:15 -0500


In a message dated 3/21/2004 9:26:38 AM Eastern Standard Time, kaczmarek@charter.net writes:

> Over the river and through the woods (about 20 miles) to Eric's Shop,
> and......
> Removed tail-lamp lenses (have new ones from Clark's to install later) and
> TL assemblies (cleaning these up at work this week.) took off the new Motor
> Mount too and lowered the dummy. Also removed the ULTRA bits of wiring
> Harness, the TL sockets were not original, and also not correct for Corvair,
> obviously ULTRA, and the  Engine Perimeter seal---what was left of
> it----Still had staples in it, so it was not ULTRA series, but GM original,
> a mere 39 years old.
> Prep with Scotchbrite pads, by hand and on angle die 
> grinder, prepped and
> sprayed.   Pictures to be sent to Ron Guy this evening.
*********************************************************************

Finally...getting to work...gg      for a moment I though you were off to Grandmas...LOL!  You work like her!

kep it up!  that meet is getting close and closer.....

West Coast Haranger

"thunder" makes the noise
"lighning" does the work
{insert Hanks byline here}