<VV> Bad piston??
Roger Gault
r.gault@sbcglobal.net
Sun, 24 Oct 2004 10:06:14 -0500
Paul,
I can't imagine that the notch will hurt anything if it is no deeper than
you describe.
Roger Gault
----- Original Message -----
From: "Paul" <ph121@concentric.net>
To: <virtualvairs@corvair.org>
Sent: Saturday, October 23, 2004 4:44 PM
Subject: <VV> Bad piston??
> Hi VV'ers,
> I need advice from the engine builders here. I just bought a "nos" set of
> standard cast pistons,sight unseen. When they arrived in the mail, I
> inspected them and found one piston with a vertical notch about 1/64 deep,
> 1/32 wide, and 3/16 long straddling the first (top) piston ring area. It
> looks like it was machined in, nice and smooth. Can I still use this
piston
> with new rings, or will I lose too much compression? I"ve taken Corvair
> engines apart, but this will be my first Corvair rebuild. Any help will
be
> appreciated. Also, what book or manual has the best rebuild instructions?
>
> Thanks,
> Paul
> CORSA member
> 64 Spyder coupe
> 64 Corvair powered dune buggy
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
the property
> of the writer, please attribute properly. For help,
mailto:vv-help@corvair.org
> This list sponsored by the Corvair Society of America,
http://www.corvair.org/
> Post messages to: VirtualVairs@corvair.org
> List info: http://www.vv.corvair.org/mailman/listinfo/virtualvairs
> _______________________________________________