<VV> Directional Light Mechanism

[Bob & Kathy Gilbert]

Again - thanks for the tip and yes it worked fine. All I had to do was hold
up the nut with both hands and pull the ring off with my third hand. :-)

Standard stuff for us Corvair folks!

I now have all electricals up and running except for the convertible top
relay.

Bob 

-----Original Message-----
From: Bob & Kathy Gilbert [mailto:bgilbert at redshift.bc.ca] 
Sent: April 3, 2005 8:48 AM
To: 'UltraMonzaWest at aol.com'; 'virtualvairs at corvair.org'
Cc: 'corvairs at cybrus.net'
Subject: RE: <VV> Directional Light Mechanism

Thanks for the tip everyone! I'll order one but with an average time for a
vendor delivery these days (post 911) to Canada being about 6 weeks I'll try
the one from the parts car first to keep the restoration process going.
Besides - it'll be good practice :-)

Bob
 

-----Original Message-----
From: virtualvairs-bounces at corvair.org
[mailto:virtualvairs-bounces at corvair.org] On Behalf Of
UltraMonzaWest at aol.com
Sent: April 2, 2005 4:23 PM
To: virtualvairs at corvair.org
Cc: corvairs at cybrus.net
Subject: Re: <VV> Directional Light Mechanism

In a message dated 4/2/05 1:01:51 PM Pacific Standard Time,
bgilbert at redshift.bc.ca writes:


> 
> Now to the parts car - how do I remove that split ring to release the 
> bearing to release the turn signal mechanism?
> 
> 
**********************************************
Put the NUT back on and pull the shaft up!

Matt
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org This list sponsored by the Corvair Society of
America, http://www.corvair.org/ Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
 _______________________________________________