<VV> door hinges

[Joe Robbins]

So easy that even I did it ! Like mentioned, once you get them out, drive
what's left of the bushing out or it may fall out, then put the new bushings
in. I bet you will find that some are still OK, but it's so easy to slap the
bronze bushings in , do them all. I think the new pin isn't knurled as far
down as stock, my pins would have been fine to reuse but since I got the new
ones not knowing any better, I used the new ones. New bushings will get you
fixed right up.

Joe Robbins
BBRT


-----Original Message-----
From: virtualvairs-bounces at corvair.org
[mailto:virtualvairs-bounces at corvair.org] On Behalf Of Dorairaj Isaac
Sent: Saturday, April 09, 2005 10:01 AM
To: VirtualVairs
Subject: <VV> door hinges

Hi,
How difficult is it to change the door hinge pins and bushes? I see that
Clarks has pins and bushed.  Do the pins just pop out and are these bushes
to be taken out or the hole bored to accommodate the new bushes?  
Thank you for any information..

Dorai <><