<VV> Rebuild II
J R Read_HML
hmlinc at sbcglobal.net
Wed Dec 21 00:03:09 EST 2005
See '65 Chassis manual - P 6-35 - fig 69, and other pages as well I imagine.
That was the first obvious one I found.
OR - just notice where the exhaust stacks are - that will tell you.
Attachments (if any) are scanned with anti-virus software.
Later, JR
----- Original Message -----
From: "Stephen Upham" <contactsmu at sbcglobal.net>
To: <virtualvairs at corvair.org>
Sent: Tuesday, December 20, 2005 10:26 PM
Subject: <VV> Rebuild II
> Well, desperation won over. Instead of trying to take the oil -generator
> adaptor off, I just decided to lift that bad boy up on its bell housing
> all by my lonesome. Went smooth as silk much to my surprise and relief.
> I have adjusted the #1 valve, but now I'm ready to do the others and now
> have run into another problem. Which of the valves is the intake and
> which is the exhaust going in the direction from rear housing cover to the
> bell housing?
>
> Stephen Upham
> Corvairium II
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
> the property
> of the writer, please attribute properly. For help,
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options:
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
More information about the VirtualVairs
mailing list