<VV> electrical tape options
JVHRoberts at aol.com
JVHRoberts at aol.com
Tue Feb 22 21:04:18 EST 2005
I either solder it, or I used a bare crimp barrel. Then the heat shrink.
There are also crimp fittings with the heat shrink already on it!
In a message dated 2/22/2005 8:08:49 AM Eastern Standard Time,
hyarnell1 at earthlink.net writes:
We used to use a heat shrink sleeve at Bendix that had a low temp solder
ring within, so that when it was hit with the heatgun, the solder would
melt, fuse the connection, and seal the joint. Slick.
But I think what Roberts is talking about is a heatshrink tubing with some
schlicum inside that will seal the PREVIOUSLY soldered joint. You DO solder
the joint, right?
More information about the VirtualVairs
mailing list