<VV> two seals in diff shaft
BobHelt at aol.com
BobHelt at aol.com
Wed Mar 30 18:08:12 EST 2005
In a message dated 3/30/05 3:04:18 PM US Mountain Standard Time,
kovacsmj at sbcglobal.net writes:
> By the way, all the ones I've done I
> found there was room for two seals back to back and the retainer.
>
OH, OH! Don't use two seals with a stock release-bearing shaft. Sure it may
look like there is room for two seals, but the problem is that the inside of
this shaft is the correct diameter for only one seal. The retaining ring is of a
slightly larger diameter and if you stick a second seal in there in its
place, it will fit loosely, eventually spinning and flopping arround destroying
both seals. Use only one seal with the stock shaft. Vendor supplied aftermarket
shafts are made to accept two seals.
Regards,
Bob Helt
More information about the VirtualVairs
mailing list