<VV> Dead Wipers

[J R Read_HML]

Corrosion in the plug on the wires at the pump end?  Bad ground at the pump 
end?  It is using the "feed" wire to find ground when you use the button? 
Just thoughts - but I think that is where I would look first.

Attachments (if any) are scanned with anti-virus software.

Later, JR

----- Original Message ----- 
From: "Ken Maxwell" <kobramax at insightbb.com>
To: <virtualvairs at corvair.org>
Sent: Wednesday, May 25, 2005 5:05 PM
Subject: <VV> Dead Wipers


Hi Guys!

I went out to my 69 convertible the other day, backed it out into the rain 
for our Econo Run and the wipers wouldn't work! They had worked fine a few 
weeks earlier. They will cycle when I push the "Wash" button, but won't work 
on either high or low. I checked the fuse and the wires, but if they were 
bad I don't think the "wash" button would work. I guess the switch has 
suddenly gone bad. Any other ideas? Thanks!

Ken Maxwell
Louisville, KY
Sunny day only 69 convertible
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are 
the property
of the writer, please attribute properly. For help, 
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, 
http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
 _______________________________________________