<VV> floor replacement

[Charles Cromwell]

Hello
I have replaced floor boards several times.Not only
for myself but for customers. Riveted most of them
into place.Hammered them like a rivet after. Did not
weld them.Then under coated them .
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>

--- Paul Hanley <ph121 at concentric.net> wrote:
> I'm replacing the floor on my 61.  I have all 4
> floor panels from Clark's.  My welding is not that
> good, so I was going to rivit them in place, then
> braze the lap joints.  Does this sound good enough? 
> Any suggestions will be appreciated. This will be a
> daily driver, not for show.
> Thanks,
> Paul
> 61 2-door coupe
> 64 Spyder
> CORSA member
>  _______________________________________________
> This message was sent by the VirtualVairs mailing
> list, all copyrights are the property
> of the writer, please attribute properly. For help,
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of
> America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options:
>
http://www.vv.corvair.org/mailman/options/virtualvairs
>  _______________________________________________
> 


		
__________________________________ 
Yahoo! Mail Mobile 
Take Yahoo! Mail with you! Check email on your mobile phone. 
http://mobile.yahoo.com/learn/mail