<VV> Straws and Lifters

[UltraMonzaWest at aol.com]

In a message dated 11/30/2005 7:11:20 AM Pacific Standard Time, 
keith.hammett at stainlessfab.com writes:

> Where does one obtain these valve covers to cut holes.  Asked sometime
> back and didn't receive a single reply on used valve covers that someone
> wanted to get rid of.  Would like a pair but will settle for one.
> 
> 
******************************************************************************
**********

You make them!   just measure the 6 rocker studs.....cut 1" holes in 
cover....

I like these better than the half covers...you can reve the engine!

Matt Nall / Patiomatt / WCUH / Mr. DeckRug
69 Monza Cpe., 66 Monza vert, 65 Crown v8 Cpe.
Somewhere between Reno, NV and Coos Bay, Or.