<VV> Engine Stand
UltraMonzaWest at aol.com
UltraMonzaWest at aol.com
Sat Apr 8 20:53:17 EDT 2006
In a message dated 4/8/2006 3:08:58 PM Pacific Daylight Time, BobHelt at aol.com
writes:
> And also
> the need for a few strong backs to lift the engine off the stand when
> finished
> (and while undoing the bolts holding it to the stand).
>
------------------------------------------------------------------------------
-------------------
AHH someone not used to working alone!! gggg
1 use a workbench close to the same height as the stand....slide on...slide
off
2 "From the floor".....lay stand on it's side......slip over tube bolted to
bellhousing... insert "anti rotation pin" and tilt stand on to its
BACK.....engine is now vertical....now..roll the stand on the rear wheels to the
upright position....
May seem awkward...but it's not...
Matt Nall / Patiomatt / WCUH / Mr. DeckRug
69 Monza Cpe., 66 Monza vert, 65 Crown v8 Cpe.
Somewhere between Reno, NV and Coos Bay, Or.
http://members.aol.com/patiomatt Corvair Info!
More information about the VirtualVairs
mailing list