<VV> Re: Gas Pump Tales

[Jim McLott]

Garth,
 
Try soaking the old heater hose with WD-40.  A little WD-40 will also help get the new one into place, too.  And good luck; attaching that heater hose with the engine still in the car is an awkward bear of a job.  BTDT.
 
Jim McLott & Christine, the 1966 Monza convertible wonder-car
Member: CORSA, Corvair Atlanta & Group Red (Ret.)
http://www.wittelaw.com/personal/groupred/mclott.htm
 
<snip>
I bought a new air tube from an unnamed vendor that runs to from the shroud to the heater box and am having a heck of a time reaching up from the bottom of the car to remove the old tube and replace it with a new tube. There must be an easier way. 

Regards, Garth
</snip>
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
 _______________________________________________