<VV> 66 Corsa 140 - No Spark
Frank DuVal
corvairduval at cox.net
Tue Aug 29 19:45:50 EDT 2006
Did you swap the tachometer and +12 volt leads? I think the tack lead is
brown, and connects with the black points lead to the negative terminal.
Time to use the voltmeter.
Frank
bmooers at farniente.com wrote:
>I am not getting any spark from my coil to the distributor on my 66
>Corsa. I had the motor out to replace the clutch and reseal the engine. I
>have double checked all connections from the harness to the coil. I also
>put in a coil from my 63 that works fine to no avail. What may be a cause
>of no spark? The car cranks over easily, I installed a new cap, rotor,
>condensor, and points. I rechecked the point gap to make sure it is
>correct. The wires are connected to the coil correctly per the shop
>manual. Any ideas would be helpful. Thanks as always!
>
>Bruce Mooers
>63 Syder Conv
>66 Corsa Conv
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>
>
>
More information about the VirtualVairs
mailing list