<VV> oil pressure switch (LM)

[Jim Houston]

SnapOn makes a 1/4" drive, 1/4" swivel socket that works very well.  I 
use a 24" 1/4" drive extension and I didn't have to remove anything to 
get the heater blower out.  To get the housing out, I think I had to 
lower the right side exhaust (but, I don't remember for sure).

Jim Houston
Lithia, FL

Frank DuVal wrote:
> Ummm, I don't recall ever having to remove an axle to R&R a heater 
> motor on any Corvair, car or truck.
>
> 1/4" socket on a 1/4" socket set does help.
>
> Frank DuVal
>
> Andy Clark wrote:
>
>> No. You just have to disconnect the hot and cold air ducts and remove 
>> the RH
>> axle and lower link. It helps if you have itty bitty double-jointed 
>> arms and
>> hands, though.
>> Andy Clark
>> 1966 140/4 Monza Sedan
>> 1966 140/4 Yenko Clone
>> 1966 180/4 Cord 8/10 #60
>>  
>>
>>  
>>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights 
> are the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________
>