<VV> Oil pump gasket leak - 63 Spyder

Dave Ziegler dziegler3 at comcast.net
Fri Jan 6 11:22:04 EST 2006


Might also want to undo the perimeter seal before lowering the engine.

Dave.. .
On Jan 5, 2006, at 5:00 PM, JVHRoberts at aol.com wrote:

>
> No problem. Block of wood across the oil pan, preferably with a small 
> pair
> supporting it at the pan rails, with a jack under it. Undo the rear 
> engine
> mount, lower as needed, and do the repair. Reverse the procedure, and 
> you're
> done!
>
> In a message dated 1/5/2006 11:10:11 A.M. Eastern Standard Time,
> bmooers at farniente.com writes:
>
> The seal  on my oil pump is leaking. In order to replace the seal and 
> stop
> the leak  I must remove the rear skid plate. Can I lower the engine 
> without
> removing  it completely? Can anyone describe the technique for this
> service?  Thanks
>
>
>
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights 
> are the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
>  _______________________________________________
>
>
Corvair Therapy
mechanical repair
light restoration



More information about the VirtualVairs mailing list