<VV> Turn signal switch removal

norman.witte at comcast.net norman.witte at comcast.net
Wed Jul 12 06:24:20 EDT 2006

I'm not sure that I understand.  I didn't see any snap ring or plastic sleeve. 

-------------- Original message -------------- 
From: "Marc Sheridan" <sheridanma at adelphia.net> 

> If you put a box end wrench on the shaft before you put the nut on, it gives 
> you a bigger handle to pull the shaft. 
> Marc Sheridan 
> > Did you remove the snap ring? Put the nut back on and pull the shaft up! 
> > It's with the plastic sleeve. 
> > 
> > Matt Nall 
> _______________________________________________ 
> This message was sent by the VirtualVairs mailing list, all copyrights are the 
> property 
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org 
> This list sponsored by the Corvair Society of America, http://www.corvair.org/ 
> Post messages to: VirtualVairs at corvair.org 
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________ 

More information about the VirtualVairs mailing list