<VV> Pertronix Ignitor

Clark Hartzel chartzel at comcast.net
Wed Jul 19 20:23:23 EDT 2006

Message: 10
Date: Wed, 19 Jul 2006 18:32:19 -0400
From: Paul Abel <pbob63 at frontiernet.net>
Subject: <VV> ignitor2 question
I just installed ignitor 2. I followed the directions. Car starts, but
won't stay running. Why? I'm using the stock coil until flamethrower
arrives. Was I correct to leave the existing wire to the + terminal of
the coil?

Did you hook up the red wire to 12 volts?  Need to run a new wire bypassing
the resistor wire.
Did you check the timing?  Mine needed about 15 degrees more advance to get
to 12 degree mark.
Don't know why the Ignitor changes timing so much but it does!
Clark Hartzel

More information about the VirtualVairs mailing list