<VV> bleeding a master cylinder
TimogensTurbo at aol.com
TimogensTurbo at aol.com
Sat May 13 10:01:11 EDT 2006
That's normal! The 2 sections are different!
---------------------------------------------------------------------
In a message dated 5/13/06 6:09:10 AM Pacific Daylight Time,
jmac2112 at adelphia.net writes:
> I've been bench bleeding my dual master cylinder, and I think I did it
> right
> but I'm not sure. I kept pumping until there were no air bubbles in the
> fliud into which I was pumping, and then I put plugs in the outlets. Now
> when I try to pump the cylinder, I get about 1/8" movement (as it should
> be), but here's the strange thing: I get a little "geyser" of fluid
> shooting up through the small hole in the reservoir further from me, but
> this doesn't happen in the nearer reservoir. I'm always suspicious when two
>
> seemingly identical components don't function the same way. Anybody out
> there know what's going on?
>
> Thanks,
>
> John McMahon
> 1965 Monza coupe
>
>
More information about the VirtualVairs
mailing list