<VV> RE: installing a cam?

[BobHelt at aol.com]

In a message dated 4/13/2007 1:43:27 PM US Mountain Standard Time,  
slowboat at mindspring.com writes:

I asked  then and I ask again
now- how do you check for tight spots in the crank  rotation after torquing
the case halves back together?
Andy  Clark



Andy, 
There shouldn't be any tight spots if the case torquing sequence was  
correctly followed. Why would you expect tight spots? That would indicate  something 
is out-of-round and would have been an initial assembly problem.
 
Regards,
Bob Helt



************************************** See what's free at http://www.aol.com.