<VV> Piston removal

[Bryan Blackwell]

Seth was correct - my aim right now is just to remove them.  I may 
venture to install some later, but right now the goal is getting them 
apart.  I will probably make up a little fixture from some tubing to 
keep things from flying around while I'm pressing the pins out.

Thanks for the replies!

--Bryan

On Feb 17, 2007, at 4:11 PM, Sethracer at aol.com wrote:

> If you are just removing the pins to use the rods and toss the 
> pistons, You
> don't need to heat them.