<VV> '67 turn signal

[Kent Sullivan]

Ernie, I just went through this in excruciating detail and have written an
article about what I found. I recommend you contact me offline and I will
explain. For the rest of you, the article is likely to show up in the
Communique in the next few months.

If you have my phone number already (from the CORSA directory), feel free to
call me until 11 PM Pacific tonight or after 8 AM Pacific tomorrow. Will be
in and out tomorrow with church and etc.

--Kent
-----Original Message-----
From: virtualvairs-bounces at corvair.org
[mailto:virtualvairs-bounces at corvair.org] On Behalf Of Ernie Sanders
Sent: Saturday, June 02, 2007 3:16 PM
To: virtualvairs at corvair.org
Subject: <VV> '67 turn signal

Anyone have step-by-step procedure for replacing my turn signal switch?  I
have gotten to the part where I am going to have to remove the cast piece
of metal that the switch is attached.  Can't figure out to get this cast
piece off.  Switch plug can't be threaded through the opening without the
cast piece being removed.  Also the housing that the wire goes through as it
goes down the steering column is a problem.  I have Tech guide and revision
and a '65 shop manual. 
These don't help.  Thanks in Advance.  Ernie in Louisville


 
____________________________________________________________________________
________
Never miss an email again!
Yahoo! Toolbar alerts you the instant new Mail arrives.
http://tools.search.yahoo.com/toolbar/features/mail/
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org This list sponsored by the Corvair Society of
America, http://www.corvair.org/ Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
 _______________________________________________