<VV> Power Top success

[Matt Nall]

Doesn't need to be stock.....  wht not a 30 amp Double pole / double throw 
toggle switch?


Matt Nall
All Vairs!
http://members.aol.com/patiomatt
Lots of Corvair Technical info!

----- Original Message ----- 
From: <tkalp at cox.net>
> Today I decided just to bolt the power parts back up and see what happens. 
> Decided to see if I could run the motor . . .  it was pretty stiff. 
> Pulled off the drive gear and found the cavity full of old hard grease . . 
> .  cleaned it up and put a dab of lith grease on the plastic gears.  Every 
> thing spun fine.  Then I couldn't figure out the wiring.  when I came home 
> for lunch I printed out the diagram provided by Padgett, figured out what 
> I was doing wrong.  Wired it up  at the bench and it ran one way swapped 
> some wiring and then it ran the other, Put it back in the car and hooked 
> up the cables and with rigged wiring the top powered down.
>
> Now I need a relay and a switch . . . stock is not required, but 
> functional is.  Any advice on what switch and relay to use.   I have seen 
> power window switches at the help section of the FLAPS   would one of 
> those work?  What relay(s)?