<VV> Dumb and Dumberer

[shortle]

I installed an engine in a 66 Monza 4 door w/PG but car would not move, even though trans worked before engine replacement.Then I removed trans only and installed a known good used unit but it would also not move. Then walking towards the backyardin bewilderment, I found the center input shaft laying in the grass.Man oh man.

-----Original Message-----
>From: Mike Jacobi <mvjacobi at comcast.net>
>Sent: Nov 18, 2007 5:39 PM
>To: virtualvairs at corvair.org
>Subject: <VV> Dumb and Dumberer
>
>How about the time I was in a tearing rush to replace the starter on the 63 Monza and rather than take the time to place jack stands as I should have, just put the rear up on a jack....and working on getting the starter off, brought the car down about half an inch from my head!!!  Scared the 10 W 30 right out of me.
>
>Or the time, (non-Vair) that my trusted mechanic, having replaced tie rods, forgot to safety wire the castle nuts.  You know, its hard to steer an 81 Chevrolet Station Wagon at 70 mph without tie rods...don't ask how I know this...the good part is that at the time I had top notch health insurance.
>
>Mike (fully recovered) in Michigan
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________