<VV> Directional Signal Assembly / Adjusting

[Matt Nall]

If nothing is broken... YES you can.....small needle nosed pliers...these 
things are not rocket science...


Matt Nall
All Vairs!
http://members.aol.com/patiomatt
Lots of Corvair Technical info!

----- Original Message ----- 
From: "Rich Purtell" <rpurtell1 at comcast.net>

I have metered out the wiring on my 1966 Corsa brake and turn signal 
circuits and have come to the conclusion the switch assembly is at fault. I 
have no brake light or directional indicator on the left side (rear). The 
front left signal does flash and the right side works both front and rear if 
you hold your mouth just right. Before I do anything drastic is there 
anything else to check? I have continuity all the way from the connector on 
the steering column to the rear lights. Is it possible to clean or bend the 
contacts on the switch or should I just go ahead and start searching for a 
replacement?

Rich 66 Corsa Conv./Houston