<VV> Directional Signal Assembly / Adjusting

[Rich Purtell]

I will pull it off the steering shaft and give it a try.

Thanks

----- Original Message ----- 
From: "Matt Nall" <nalllm at verizon.net>
To: <virtualvairs at corvair.org>
Sent: Monday, October 15, 2007 7:32 PM
Subject: Re: <VV> Directional Signal Assembly / Adjusting


> If nothing is broken... YES you can.....small needle nosed pliers...these 
> things are not rocket science...
>
>
> Matt Nall
> All Vairs!
> http://members.aol.com/patiomatt
> Lots of Corvair Technical info!
>
> ----- Original Message ----- 
> From: "Rich Purtell" <rpurtell1 at comcast.net>
>
> I have metered out the wiring on my 1966 Corsa brake and turn signal 
> circuits and have come to the conclusion the switch assembly is at fault. 
> I have no brake light or directional indicator on the left side (rear). 
> The front left signal does flash and the right side works both front and 
> rear if you hold your mouth just right. Before I do anything drastic is 
> there anything else to check? I have continuity all the way from the 
> connector on the steering column to the rear lights. Is it possible to 
> clean or bend the contacts on the switch or should I just go ahead and 
> start searching for a replacement?
>
> Rich 66 Corsa Conv./Houston
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________
>