<VV> LOADSIDE-- NO GO-- CLUTCH/SHIFT QUESTION
Mike Kost
vairmike at sbcglobal.net
Thu Sep 13 09:06:40 EDT 2007
Bob,
Check (I know it means pulling the engine AGAIN) to make sure the clutch
disk isn't in backward. Another possibility is a riveted clutch disk
rubbing on the flywheel bolts. Are you sure you don't still have a mix
of flywheel and pressure plate parts?
Mike Kost
SMCC
bs wrote:
> Last week I asked about the possibility of rebuilding a clutch cable, that was a possible project for later in the winter
>
> Here's where I am at today...
>
> We reinstalled a rebuilt motor this week. Two weeks ago we put it in, but couldn't get it into gear, laid rubber in reverse in my garage, wouldn't shift into any other gear.
>
> Pulled the engine and tranny <again> swapped throwout bearings because we had mixed early and late tranny-diff and clutch plate-flywheel.
>
> Replaced engine today, started up, same problem. Squealed in Reverse again, but very tough to get into ANY gear, even when motor is not running.
>
> Rechecked clutch connections, seems ok. did the three complete turns out to adjust, etc. At times there is a lot of free play at the top of the pedal, if I pump the clutch, seems to tighten up a bit, but still doesn't want to shift gears.
>
> ANY THOUGHTS?
>
> Thanks!
>
> Chaplain Bob
More information about the VirtualVairs
mailing list