<VV> Part Number Question...

[John Sweet]

Just order it from a Corvair parts vendor.
John Sweet
----- Original Message ----- 
From: "Ian Harding" <harding.ian at gmail.com>
To: "Virtual Vairs" <virtualvairs at corvair.org>
Sent: Wednesday, September 26, 2007 5:11 PM
Subject: <VV> Part Number Question...


> Anyone know the GM part number for the input shaft seal retaining
> ring?  This is what it looks like
>
> http://gmpartswiki.com/w/Image:CorvairInputShaftRing.jpg
>
> and this is the closest part number I could find.  It's in the same
> group as the shaft
>
> http://gmpartswiki.com/w/RING%2C_Transmission_Input_Shaft_Retaining_%284.123%29
>
> but the only part listed there is an 11/16 clip for a 5/8 shaft.  The
> one I am looking at is about 1 1/8 OD and 1/8 thick and is for
> installation in a bore, not on a shaft.
>
> Thanks,
>
> - Ian
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>
>