<VV> Part Number Question...

[Ian Harding]

I don't need one, I actually have the one I took a picture of!  I'm
just curious.

On 9/26/07, John Sweet <jasvair at certainty.net> wrote:
> Just order it from a Corvair parts vendor.
> John Sweet
> ----- Original Message -----
> From: "Ian Harding" <harding.ian at gmail.com>
> To: "Virtual Vairs" <virtualvairs at corvair.org>
> Sent: Wednesday, September 26, 2007 5:11 PM
> Subject: <VV> Part Number Question...
>
>
> > Anyone know the GM part number for the input shaft seal retaining
> > ring?  This is what it looks like
> >
> > http://gmpartswiki.com/w/Image:CorvairInputShaftRing.jpg
> >
> > and this is the closest part number I could find.  It's in the same
> > group as the shaft
> >
> > http://gmpartswiki.com/w/RING%2C_Transmission_Input_Shaft_Retaining_%284.123%29
> >
> > but the only part listed there is an 11/16 clip for a 5/8 shaft.  The
> > one I am looking at is about 1 1/8 OD and 1/8 thick and is for
> > installation in a bore, not on a shaft.
> >
> > Thanks,
> >
> > - Ian
> > _______________________________________________
> > This message was sent by the VirtualVairs mailing list, all copyrights are
> > the property
> > of the writer, please attribute properly. For help,
> > mailto:vv-help at corvair.org
> > This list sponsored by the Corvair Society of America,
> > http://www.corvair.org/
> > Post messages to: VirtualVairs at corvair.org
> > Change your options:
> > http://www.vv.corvair.org/mailman/options/virtualvairs
> > _______________________________________________
> >
> >
>
>
>