<VV> Ceramic Bearings for Blower & Idler Applications

[Ron]

Are any the right size?  If not, you're wasting your time thinking about it.
RonH

----- Original Message ----- 
From: <Mikeamauro at aol.com>
To: <virtualvairs at corvair.org>; <fastvair at yahoogroups.com>
Sent: Monday, December 08, 2008 8:38 AM
Subject: <VV> Ceramic Bearings for Blower & Idler Applications


> Is anyone using, or have considered use of hybrid or full ceramic bearings
> in blower or idler applications? Ceramic bearings boast ability to hold up
> better than standard bearing under high RPM/heat conditions. The hybrids 
> are
> reasonably priced. Following is a link to one supplier:
> _http://www.vxb.com/page/bearings/CTGY/CeramicBallBearings_
> (http://www.vxb.com/page/bearings/CTGY/CeramicBallBearings)
>
> Mike Mauro
> **************Stay in touch with ALL of your friends: update your AIM, 
> Bebo,
> Facebook, and MySpace pages with just one click. The NEW AOL.com.
> (http://www.aol.com/?optin=new-dp&icid=aolcom40vanity&ncid=emlcntaolcom00000012)
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>