<VV> Lifter Bore Repair
corvairs
corvairs at pacifier.com
Thu Dec 11 15:58:58 EST 2008
How much did the repair cost? Lon
Geoffrey Johnson wrote:
> I have seen this mentioned here before.
>
> We got a '65 500 Four Door a while back. Really cool car complete
> stripper minus the 140
> four speed. Motor was siezed hard! Tear down revealed a spun
> bearing on #5, and #2 rod thrown so hard it had punched through the
> lifter area. Had likely brought the car to a screeching halt as well,
> the flywheel bolt heads were sheared and there was a 3/8th's inch divot in
> the crank. We discovered the protecto plate - with block number. So
> we wanted
> to save the block. Found a old timer ( he is listed in the Care and
> Feeding of your Corvair guide) who rebuilt the area with TIG fill and
> sleeved and rebored the lifter bores.
>
> Here is a picture:
>
> http://www.unm.edu/~geoffj/images/Host/Sleeved-Lifer-Bores.jpg
>
> Result is we saved the block which is low mileage and original to the car.
>
> -Geoff Johnson
> Albuquerque NM
>
>
More information about the VirtualVairs
mailing list