<VV> LM power top motor installation.

[jimster1]

Mike, 
Step one lube with something slippery.  Next take an appropriate sized Allen
driver and stick it in the hole in the rubber nipple.  You want the Allen to
fit pretty closely.  Next, shove mightily in order to stretch the rubber out
and made it slimmer.  Kinda crank the Allen in a circle and the nipple will
work its way into the hole.
Jim

-----Original Message-----
From: virtualvairs-bounces at corvair.org
[mailto:virtualvairs-bounces at corvair.org] On Behalf Of Michael Kovacs
Sent: Monday, July 21, 2008 1:43 PM
To: VV
Subject: <VV> LM power top motor installation.

Does someone out there have the solution to insert the three rubber mounting
widgets into the three holes in the sheet metal? 
 
 I've tried to lube them, push, hammer, twist, press.............whatever,
but have limited success. Do I need a BFH !!!!!!!!!!!?
 
 While at Hemmings car show on Saturday the top stopped half the way up. No
problem,  just unscrewed the cables and hand raised the top. The motor works
after reconnecting a wire, but now motor is not attached to car. 
 MIKE KOVACS 
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property
of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America,
http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
 _______________________________________________