<VV> FW: special tool?

[sharpiebandit06 at bellsouth.net]

 I  used a short necked closed end wrench.


Charles   6/3/08-------------- Forwarded Message: --------------
From: cfm <cfmann at yahoo.com>
To: Virtual Vairs <virtualvairs at corvair.org>
Subject: <VV> special tool?
Date: Tue, 3 Jun 2008 20:00:03 +0000


dear corvair masters,
um, how in the heck to you get a wrench on the 9/16" bolt that holds down the 
distributer? My standard wrench doesn't like this area very well.
do I cut on off or something? or get a closed offset 9/16"?
69 monza 'vert (with a 110hp/pg from a 65,66 or 67)
chris
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the 
property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
 _______________________________________________