<VV> (no subject)

[Harry Yarnell]

Leaking oil pans are often caused by mushroomed bolt holes.
Get some 3/4" thick wood as a base for tapping the holes flat with a ball 
peen hammer.
As for the RTV, you'll get both postive and negitive comments, but I'll put 
a small bead on the pan side only.

harry yarnell
poohbah of Perryman
perryman garage and orphanage
hyarnell1 at earthlink.net
----- Original Message ----- 
From: "John Gull" <johngull at bellsouth.net>
To: <virtualvairs at corvair.org>
Sent: Sunday, March 16, 2008 8:55 AM
Subject: <VV> (no subject)


> Looking for some great advice on repairing a leaking oil pan . 66 manual
>> trans 140 motor. Should I use rtv on both sides of cork nitrile gasket?
> Any
>> other recommendations on what to address at the bottom end of motor while
>> oil pan is off? Many thanks John
>
>
>
> John Gull
>
> Asheville, NC 28816
>
> 828-712-7902
>
>
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>