<VV> AC BLOCK CODE

[J R Read_HML]

Someone put an FC rear housing on a car engine.
Later, JR

----- Original Message ----- 
From: "Rod Murray" <rmurray at anaheimducks.com>
To: "CORVAIR" <virtualvairs at corvair.org>
Sent: Saturday, May 10, 2008 4:48 PM
Subject: <VV> AC BLOCK CODE


> Ok engine code detectives.....Just picked up a block for engine rebuild 
> project...code T0203AC...AC per clarks book = 95hp smog w manual tranny 
> for '69...but couple interesting things...code located on right side of 
> block vs normal left side location...also, it has BOTH oil check locations 
> in the block mold (standard AND FC) but neither have been drilled out...so 
> its an unused block?  And why would a 69 block have the fc oil fill setup? 
> The 65 monza case I pulled parts from doesn't have it.  Was AC code used 
> from 61-65?  If so, it doesn't show in clarks engine code section...
>
> Any thoughts?
>
> Rod
> 66 monza
> 64 greenbrier (getting the engine rebuild)
>
> Thanks
> Rod's Treo
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________