<VV> Throttle linkage question

[Jim Houston]

I've replaced all the bushings/rubber/etc in the whole system (including 
a new pedal pivot assembly).  The only slop remaining is at the two 
pivots on the crossbar between the carbs.

Thanks for all the replies!

Jim

HallGrenn at aol.com wrote:
> In a message dated 10/27/2008 2:36:04 P.M. Eastern Daylight Time, 
> bryan at skiblack.com writes:
>
>     While you're at it, get the bushing for 
>     the throttle bellcrank under the car, it's not very expensive at all.
>
>     --Bryan
>
> In fact, replace it first if it is bad--the single best linkage repair 
> I've made before going to blocks (on one car).
>  
> Bob Hall
> Group Corvair
>
>
>
> ------------------------------------------------------------------------
> Play online games for FREE at Games.com! All of your favorites, no 
> registration required and great graphics – check it out! 
> <http://pr.atwola.com/promoclk/100000075x1211202682x1200689022/aol?redir=%0Ahttp://www.games.com?ncid=emlcntusgame00000001>