<VV> Vacuum hose connections : 1967 110 Monza PG

[shortle]

Charlie,
The vacuum advance hooks up to "ported" vacuum on the RH carb.(above the throttle plate-vertical connection). The lower horizontal connection (manifold vacuum-below the throttle plate) hooks up to the choke pulloff diaphragm. All this information can be found in the shop manuals. I hope this helps.
Timothy Shortle in Durango Colorado

-----Original Message-----
>From: Charles Lee <chaz at ProperProPer.com>
>Sent: Sep 15, 2008 10:35 PM
>To: virtualvairs at corvair.org, rusecular at yahoo.com
>Subject: <VV> Vacuum hose connections : 1967 110 Monza PG
>
>Is there a "vacuum diagram" for the 1967 Monza ?
>
>I believe the vacuum advance hooks to the inlet at the base of the right
>(passenger) carb, and the vacuum crossover does the rest ?
>
>Anything else I ned to consider to make sure this is not a problem when
>I get the new plug wires and try to fire her up ?
>
>I've siphoned gas through the fuel lines all the way to the inlet to
>each fuel filter, and checked the elcttrical connections, re-set the
>distributor to TDC #1, and hooked up all the leads according to my
>memory, figure 12-27 in the manual (plus all the help from those who
>checked my diagrams), so I think she should be good to go, I'm hoping
>literally.
>
>She ran when I bought her, but it was stripped down a while back and I
>hope I got all the parts back where they belong.
>
>This step is vacuum, so any help would be appreciated !
>
>Thanks in advance,
>Charlie
>
>
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________