<VV> Distributor cap

J R Read_HML hmlinc at sbcglobal.net
Fri Apr 17 00:18:46 EDT 2009


Made in China?

Try a regular Corvair vendor.
Later, JR

----- Original Message ----- 
From: <mwclarke01 at gmail.com>
To: <virtualvairs at corvair.org>
Sent: Thursday, April 16, 2009 11:17 PM
Subject: <VV> Distributor cap


>I recently decided to change out the distributor cap on my '63 Monza as the 
>cap had a small crack forming around the hold down bolt.  I was doing this 
>more for precautionary reasons as the car is running okay.  Anyway, after 
>installing a new cap purchased at the local FLAPS the engine would start, 
>but did not run as smooth as before.  I feel certain that I installed 
>properly as I followed the firing order in the same order as the old one. 
>Since I plan on driving the car to the local chapter meeting tomorrow 
>night, I put the old cap back on and it's running smooth again.  Any 
>thoughts on what may be causing a problem with the new one? I double 
>checked the part number back to the AutoZone website and it matches up 
>correctly.
>
> Mark Clarke
> Corvair Houston
> '63 Monza Cvt, 84hp, pg
> Sent via BlackBerry by AT&T
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________ 



More information about the VirtualVairs mailing list