<VV> clutch pilot bushing removal tool

[Mark Durham]

This slide hammer puller works great, its what I used, Harbor Freight,
$19.99.

http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=5469
Mark durham
On Fri, Dec 11, 2009 at 5:21 PM, Test User <vair65 at sisna.com> wrote:

> check out the tool on www.SpringerTool.com <http://www.springertool.com/><
> http://www.springertool.com/>.
> ordered a medium sized one to remove the roller bearing bushing that had
> been in the engine since 1986. came out in 5 minutes with no cleanup. when
> you look at the order page it says the med will go down to .4?? which is
> incorrect. when the screw is removed the pilot bushing hole has to be .555
> for the tool to clear. stock bushing measues .590 so it shouldn't be a
> problem. after inserting the tool you insert the screw and once it's
> against
> the crank the bushing will start to come out. he's in the process of making
> a new design but this will do the job. the small size won't work. it's a
> very well made tool and i don't see how he can make, sell and mail for $25.
> no more grease, bread or whatever(VBG)-mike mann
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
> the property
> of the writer, please attribute properly. For help, mailto:
> vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options:
> http://www.vv.corvair.org/mailman/options/virtualvairs
>  _______________________________________________
>