<VV> Crankshaft again!

[Jim Houston]

That was my impression -- I just ordered another bushing from Clark's.  
I'll measure it and this one, hopefully this one is undersize...  if 
that isn't the problem, then it has been suggested I get a 60's Chevy 
bushing (same length and I.D.) and have the O.D. turned down to .002 
oversize... sounds like a plan..

Jim Houston


Michael Kovacs wrote:
> I've always had to gently drive the bushing in with the shaft!
>  MIKE KOVACS 
>
>
>
> ----- Original Message ----
> From: Jim Houston <jhouston001 at cfl.rr.com>
> To: Virtual Vairs <virtualvairs at corvair.org>
> Sent: Mon, December 21, 2009 6:13:49 PM
> Subject: <VV> Crankshaft again!
>
> .........  anyway, I went to install the NEW pilot bushing and I was able 
> to push it all the way into the crank using my fingers.  Somehow, this 
> doesn't seem right?  Any suggestions or comments??  Do they make an 
> oversized bushing??
>
> Thanks in advance,
>
> Jim Houston
> '65 Corsa
> _______________________________________________
>   
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com 
> Version: 8.5.427 / Virus Database: 270.14.116/2579 - Release Date: 12/21/09 07:36:00
>
>