<VV> Electric fuel pump inertia switch

Jack Kean jkean at sbcglobal.net
Tue Jun 9 23:47:29 EDT 2009


on my late model, I installed mine on the support below the left decklid 
lift (in front of the battery). Ran power from the fuse block to the 
inertia sensor on to relay that supplies the pump.

jack kean
arlington, Tx

shortle wrote:
> I decided on my Rampside to start living a little less dangerously and to (finally) install an inertia switch. I went to the junkyard over the weekend and went into the Ford section (I think the second time in my life I was in that section) and was amazed at the number of cars that came equipped with them. I grabbed a couple while I was there and now am ready to install. I noticed everyone was mounted vertically and was wondering where others have mounted them on their Corvairs. Do you guys (and gals) put a fuse before this switch or after for that matter? I am also going to install one in my ongoing project '62 Monza Wagon. Anyone?
> Timothy Shortle in Durango Colorado
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
>  _______________________________________________
>
>   


More information about the VirtualVairs mailing list