<VV> cylinder studs

[shortle]

Yes. But on my engine, I used a wire brush along with a lubricant (WD40 I think) and just used an old headnut running it up and down all the threads. I hope this is helpful.
Timothy Shortle in Durango Colorado.
-----Original Message-----
>From: Jim Houston <jhouston001 at cfl.rr.com>
>Sent: Jun 25, 2009 2:35 PM
>To: Virtual Vairs <virtualvairs at corvair.org>
>Subject: <VV> cylinder studs
>
>Okay guys, refresh my memory -- is it okay to clean up the threads on 
>head studs with a die??
>
>Thanks in advance,
>
>Jim Houston
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________