<VV> Fuel tank sending unit issue

[Daniel Monasterio]

If my memory still serves 30 Ohms is for earlies, 90 Ohms for lates.

 

Daniel
 
> From: hmlinc at sbcglobal.net
> CC: virtualvairs at corvair.org
> Date: Mon, 23 Nov 2009 17:58:08 -0600
> Subject: Re: <VV> Fuel tank sending unit issue
> 
> Chuck... 40 is for EMs and 90 is for LMs
> Later, JR
> 
> ----- Original Message ----- 
> From: "charles mckinley" <cmckinley313 at cox.net>
> To: "David Heath" <dheath at vanceandhines.com>
> Cc: "VV" <virtualvairs at corvair.org>; "Michael Kovacs" 
> <kovacsmj at sbcglobal.net>
> Sent: Monday, November 23, 2009 5:57 PM
> Subject: Re: <VV> Fuel tank sending unit issue
> 
> 
> > I'll second that. I've been through three sending units, all supposedly
> > stock, and none of them read the same for corresponding tank levels. The
> > first two had nominally 40-ohm resistance for full tank, the last one is
> > 90-ohms. As the gas gauge is basically nothing more than an ohm-meter,
> > you need to get used to whatever it says, especially near empty! Mine
> > now reads about 1/8 full when there's 2.5 gallons in it. That's good
> > enough for me.
> >
> > Chuck McKinley
> > '63 Monza 900
> >
> > 
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________
 		 	   		  
_________________________________________________________________
Descubre IE8 con Otto
 www.otto.com.mx