<VV> REAR HOUSING OIL LEAK REPAIR

[N2VZD at aol.com]

(flame suit on)  i have repaired at least 2 of them for others and one  for 
myself by cleaning the area well with solvents , and warming it up with a  
heat gun , then adding the good gray locktite epoxy. if it is warm enough , 
the  stuff flows in place and stays there. leave it alone a few hours before 
running  it. that leak probably is under slight pressure from the pump.
i now do that repair to any housing i have off the motor when building  etc.
so far i have no comebacks on this repair. it is very hard to see this  
repair unless you are really looking for it.
some of my motors end up getting painted in this area  anyway's.
regards, tim colson