<VV> Insulation or Jute Padding

[J R Read_HML]

The original carpets (pads) were not glued to the floor.  A PO has left you 
a problem.  Don't make the same mistake upon install.
Later, JR

----- Original Message ----- 
From: "Ed Orbea" <ed.orbea at gmail.com>
To: <virtualvairs at corvair.org>
Sent: Tuesday, July 27, 2010 5:56 PM
Subject: <VV> Insulation or Jute Padding


>I am almost done with the rebuild of my 62 Monza. I am now starting in
> the interior floor. I have removed the seats and the carpet (new carpet
> from ACC has been delivered). I want to put down dynamat under the
> carpeting. What is the best way to remove the old glued on fiber
> padding. I have scrapped a lot of it off with a scrapper, but need to
> get the old glue and fibers out so that the dynamat has a good chance of
> sticking. What is the best way to do this?
> Could I get some 3M adhesive release, spray it good and the scrape, or
> use a wire brush or even a wire wheel (attached to my drill), or????
>
> Thanks
>
> Ed Orbea
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________