<VV> Pulled stud question
Brent Fullard
brent.fullard at rogers.com
Sun Apr 24 11:14:27 EDT 2011
Wouldn't a Heli-Coil® solve this problem, rather than welding a re-tapping and
the expense of a machine shop?
See: http://www.emhart.com/brands/heli-coil/
________________________________
From: Tony Underwood <tony.underwood at cox.net>
To: virtualvairs at corvair.org
Sent: Sun, April 24, 2011 11:04:58 AM
Subject: Re: <VV> Pulled stud question
At 08:19 PM 4/23/2011, Bryan Blackwell wrote:
>If you're tearing it all the way down you could also consider having
>the case welded up and re-tapped. I would use a machine shop that
>you are confident of.
>
>--Bryan
>
>On Apr 23, 2011, at 7:19 PM, Karl Haakonsen wrote:
>
> > (Forwarding to list for closeup)
> >
> > Thanks Bob, I will do that.
> >
> > Btw, here is a sort of closeup:
> >
>http://www.chezhawk.com/VairBlog/wp-content/uploads/2011/04/IMG_0978-1024x768.jpg
>g
>
>
Then again, it looks like there's plenty of room for an insert.
tony..
_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the
property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
_______________________________________________
More information about the VirtualVairs
mailing list