<VV> AC Bezel Install

[Dennis Pleau]

Has anyone contacted Mark Corbin?  He probably knows a lot about the bezels,
both the plastic and metal versions.

dp

-----Original Message-----
From: virtualvairs-bounces at corvair.org
[mailto:virtualvairs-bounces at corvair.org] On Behalf Of AeroNed at aol.com
Sent: Thursday, January 13, 2011 8:27 PM
To: VirtualVairs at corvair.org
Subject: Re: <VV> AC Bezel Install

Very good point, Terry. The plastic repo I have is NOT a good one at all. I 
 wonder if he could shoot it and then clean it up. Could be a good 
discussion at  the Tuna, if one of us remembers!
 
Ned
 
 
In a message dated 1/12/2011 11:38:47 A.M. Central Standard Time,  
tkalp at cox.net writes:

Actually  many machine shops have the ability to computer measure an 
existing part, then  use that geometry to set up the tool paths for a CNC
machine. 
 The  machinist contact that Aeroned mentioned has that ability.  Anyone 
have a  good spare bezel to be measured?

Terry Kalp
Wichita,  KS


---- jimster1 <jimster1 at earthlink.net> wrote: 
>  Actually the solid aluminum bezel was milled out of a solid piece not  
cast.
> If only there was a CNC tape for the thing, someone could spit  'em out 
like
> cookies.  Having both, the plastic and aluminum  bezels, I installed the
> aluminum one as it is the correct shape.   It would be perfect if it had a
> bright chrome finish.  As it is,  it's like a satin finish.
> Jim '66 turbovert w\air   whoopee!!!