<VV> PG bellhousing for MT
jvhroberts at aol.com
jvhroberts at aol.com
Sat Jan 22 07:05:46 EST 2011
Not an issue, since the ball stud is on the diff.
John Roberts
-----Original Message-----
From: Dave Ziegler <dziegler3 at comcast.net>
To: HallGrenn at aol.com
Cc: virtualvairs at corvair.org; bryan at skiblack.com
Sent: Fri, Jan 21, 2011 4:43 pm
Subject: Re: <VV> PG bellhousing for MT
Also doesn't have the ball stud for the clutch fork.
Dave.. .
On Jan 21, 2011, at 3:45 PM, HallGrenn at aol.com wrote:
> Bryan,
>
> It won't work. The PG doesn't have the opening for the clutch rod
> etc.
>
> Bob
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all
> copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-
> help at corvair.org
> This list sponsored by the Corvair Society of America, http://
> www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/
> virtualvairs
> _______________________________________________
_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the
property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
_______________________________________________
More information about the VirtualVairs
mailing list