<VV> [FC] Concern on head removal

[Mark Durham]

You should be OK by removing both studs and lowering just a bit.
Remove the tin around the engine and do some measurements. You should
be able to tell how much you will need to lower the aft end.  Mark
Durham

On Mon, Jul 18, 2011 at 11:52 AM, BBRT <chsadek at comcast.net> wrote:
> Years ago, I did it to replace a cylinder in a 64 FC Van. Think it was right
> side..been a looooong time ago.
>
> Chuck S
> ----- Original Message -----
> From: "Daniel Monasterio" <dmonasterio at hotmail.com>
> To: "VirtualVairs" <virtualvairs at corvair.org>; "CORVANATICS"
> <corvanatics at corvair.org>
> Sent: Monday, July 18, 2011 2:46 PM
> Subject: [FC] Concern on head removal
>
>
>>
>> Need to remove/replace left head on a Greenbrier but, don't remember if it
>> is possible and/or practical to remove it without removing powertrain just
>> by lowering engine. Have done easily on LM cars but, my memory is not
>> working well about this on FCs.
>>
>> Thanks in advance
>>
>> Daniel Monasterio
>>
>> _______________________________________________
>> Corvanatics mailing list
>> Corvanatics at corvair.org
>> http://www.vv.corvair.org/mailman/listinfo/corvanatics
>> This list sponsored by the Corvair Society of America,
>> http://www.corvair.org/
>>
>>
>> -----
>> No virus found in this message.
>> Checked by AVG - www.avg.com
>> Version: 10.0.1390 / Virus Database: 1516/3772 - Release Date: 07/18/11
>>
>
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
>  _______________________________________________
>