<VV> Pitman arm needle bearing?

[Ron]

The plastic bushing that Lon makes works just fine.
RonH

----- Original Message ----- 
From: <Sethracer at aol.com>
To: <jvhroberts at aol.com>; <virtualvairs at corvair.org>
Sent: Monday, March 07, 2011 8:01 AM
Subject: <VV> Pitman arm needle bearing?


>
>
> In a message dated 3/7/2011 6:36:26 A.M. Pacific Standard Time,
> jvhroberts at aol.com writes:
>
> Just  some food for thought. Personally, the stock setup works rather
> well, the  only caveat is that *&?^ %$#@ rubber bushing attaching the
> relay rod  to the Pitman arm. That needs to be a precision needle
> bearing sealed  setup, IMHO. The rest is plenty stiff enough.
>
> John  Roberts
>
>
>
> John - Do you know if anyone has ever offered a sealed needle  bearing
> replacement for this bushing? I have never seen one. Maybe  something out 
> of a
> idler arm assembly?
>
>
>
>
> Seth Emerson
>
> C's the Day! -  Corvair, Camaro, Corvette
> San Jose, CA
>
>
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>
>
>